How to clean a 3 axis press brake

Cleaning the 3 axis press brake is an important maintenance step. Here are some detailed cleaning steps of 3 axis press brake :

1. Preparation work for cleaning 3 axis press brake:

Make sure the press brake is turned off and the power supply is disconnected to ensure safe operation. Clean the work area and remove clutter and debris from around it.

2. Clean the external surface of 3 axis press brake:

Use a clean damp cloth or soft brush to remove dust and dirt from the outside of the press brake. For stubborn stains, use a mild cleaner, but avoid caustic or abrasive chemicals. Be especially careful when cleaning operating panels, control boxes and other electronic components to avoid moisture entering electrical components.

3. Clean the slider and mold of 3 axis press brake:

Remove the slide and mold (if possible) and use compressed air to blow away dust and debris from the surface. Use a special metal cleaner and a soft cloth to clean the surface of the slider and mold to remove oil and oxides. For hard-to-clean areas, use a cotton swab or fine brush.

4. Clean the hydraulic system of 3 axis press brake:

Check the oil tank of the hydraulic system. If the oil is dirty or contains impurities, replace the hydraulic oil and clean the oil tank. Clean hydraulic lines and fittings and use compressed air to blow away dust and debris inside. Replace the filter element of the hydraulic system to ensure filtration effect.

5. Clean the lubrication system of 3 axis press brake:

Check the oil tank and pipes of the lubrication system. If the oil is dirty or contains impurities, the lubricating oil needs to be replaced and the oil tank cleaned. Clean the nozzles and pipes of the lubrication system to ensure that the oil can smoothly reach the parts that need lubrication.

6. Clean the cooling system of 3 axis press brake:

If the press brake is equipped with a cooling system, the coolant tank and pipes need to be cleaned regularly to prevent the accumulation of sediment and impurities. Replace the coolant (if necessary) and add appropriate additives as recommended by the manufacturer.

7. Reassembly and testing of 3 axis press brake:

After all parts have been cleaned, reassemble the press brake in the correct order. Start the press brake and perform a simple test to make sure everything is functioning properly and there are no unusual sounds or vibrations.

It should be noted that different press brake models and brands may have different cleaning and maintenance requirements, so it is best to refer to the equipment’s operating manual or consult the manufacturer’s recommendations before cleaning and maintenance.

3 axis press brake
3 axis press brake

We use cookies to enable all functionalities for best performance during your visit and to improve our services by giving us some insight into how the website is being used. Continued use of our website without having changed your browser settings confirms your acceptance of these cookies. For details please see our Privacy Policy .